![]() The documentation directory for information about compilation. PrusaSlicer is based on Slic3r by Alessandro Ranellucci and the RepRap community. SuperSlicer is based on PrusaSlicer by Prusa Research. It's compatible with any modern printer based on the RepRap toolchain which is running a firmware based on Marlin, Prusa, Klipper, etc. Instructions for FFF printers or PNG layers for mSLA 3D printers. SuperSlicer takes 3D models (STL, OBJ, AMF) and converts them into G-code Click on the build for your platform and then on 'Artifacts (1)' in the top right corner. Nightly builds are available through the git actions page. Windows users can use chocolatey or scoop. The Linux & macOS builds aren't tested (by me), just compiled, so please report any bugs that may occur during use.įor installers, check the badges above. Prebuilt Windows, Linux and macOS 64-bit releases are available through the git releases page. ![]() A PrusaSlicer fork (which is a slic3r fork) (previously Slic3r++)
0 Comments
Leave a Reply. |